Introduction
Zigbee Door/Window Sensor
User Manual V1.0
SenseGuard DW Gen2 is a Zigbee door/window sensor equipped with a tamper-protection feature. It detects the opening and closing status of doors and windows through the proximity and separation between the transmitter and the magnet. The magnet supports various mounting options, making it suitable for different door and window types. Powered by AAA batteries, the device allows easy replacement and long-term use. Its open/close and tamper status can be used in smart scenes to trigger other smart devices, enabling security functions such as lighting control, sound and light alarms, camera recording 
, and app notifications.
Versatile Mounting
Tamper Alert
Smart Scene
App Notification
① Transmitter
② LED indicator (Red)
③ Magnet
④ Alignment mark for installation
⑤ Button
LED Indicator Status
|
Status |
Description |
|
Flash slowly for 180s |
First-time power on/Press and hold button for 5s to enter the pairing mode |
|
Keep on for 3s and then keep off |
Pairing successful |
|
Exit flashing slowly and keep off |
Pairing failed/Pairing timeout |
|
(after short pressing the button) Flash once quickly |
Not added to the gateway |
|
(after short pressing the button) |
Added to the gateway and online |
|
Two short flashes followed by one long flash, repeated for 30s |
Abnormal communication |
Specification
Download the eWeLink App
Please download the “eWeLink” App from Google Play Store or Apple App Store.
Power On the Device
Open the transmitter enclosure with a screwdriver
Take out the battery insulation sheet to power on the device
If used for the first time, the device will enter pairing mode by default after being powered on, and the LED indicator will be in a slow flashing state.
If the device is not paired within 3 minutes, it will exit pairing mode. To re-enter pairing mode, long press the device button for 5 seconds until the LED indicator is in a slow flashing state.
Add a Device
Zigbee Pairing
① Add SONOFF Zigbee gateway
|
Matched Gateways |
|
|
Recommended SONOFF gateway models: |
ZBBridge-P, ZBBridge-U, NSPanel Pro, iHost |
|
Other compatible SONOFF gateway models: |
ZBDongle-P, ZBDongle-E, Dongle-M, Dongle-PMG24, Dongle-LMG21 |
② Add device
Enter “Scan”
Scan the QR code on the device
Select “Add Device”
(If the device exits pairing mode)
Long press the button for 5 seconds
Check the LED indicator’s flashing status (Slow flash)
Select a Zigbee gateway
Wait until the addition is done
Effective Communication Range Verification
Short press the device button at the desired location for installation. If the sensor is within the effective communication range of the hub or router on the same Zigbee network, the LED indicator will flash twice.
Installation
Apply the 3M adhesive to the designated area on the device
The magnet can be installed either horizontally or vertically
(For horizontal installation: When the door/window is closed, the installation gap between the transmitter and the magnet should be less than 30 mm. For vertical installation: The installation gap should be less than 15 mm.)
Open the magnet enclosure with a screwdriver
Detach and install the magnet
Replace the Batteries
Remove the battery cover to replace the batteries.
When replacing, use batteries of the same type.