Install the Battery Base.
Next

Remove the battery insulation strip to power on the device.

Next

After power-on, the screen will display “Setup”. Double-press the middle button to adjust the screen orientation.

Next

When the screen shows “Ready”, align the device with the battery base already installed on the valve, then rotate the device to lock it in place.

Next

After the device is firmly installed, quickly press the middle button.

Next

The screen will display a “Calibrate” animation, indicating that the device is adapting to the valve. Upon success, the screen will show the current room temperature.

Next

In Manual mode, rotate the knob to lower the set temperature until the screen displays “OFF”

Next

When the device is OFF, long press the middle button for 2 seconds

Next

Check that the pairing icon “” is flashing

No
Yes